WAGO Modular IO System INTERBUS S Manuel de service télécharger pdf (Page 35)

Field Supply • 35

Fusing

WAGO-I/O-SYSTEM 750

INTERBUS

Warning

In the case of power supply modules with fuse holders, only fuses with a

maximum dissipation of 1.6 W (IEC 127) must be used.

For UL approved systems only use UL approved fuses.

In order to insert or change a fuse, or to switch off the voltage in succeeding

bus modules, the fuse holder may be pulled out. In order to do this, use a

screwdriver for example, to reach into one of the slits (one on both sides) and

pull out the holder.

Fig. 2-15: Removing the fuse carrier p0xxx05x

Lifting the cover to the side opens the fuse carrier.

Fig. 2-16: Opening the fuse carrier p0xxx03x

Fig. 2-17: Change fuse p0xxx04x

After changing the fuse, the fuse carrier is pushed back into its original

position.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 81 82

Pas de commentaire

WAGO Modular IO System INTERBUS S Manuel de service Page 35